How To Rebuild A GM Starter Part 2

Part 2 of 2

In part one of our GM starter rebuild, you were able to see Josh take apart the starter and find out what parts needed to be replaced and cleaned. In part two, Josh puts it all back together nicely so we have a fresh starter to use if needed.

The parts used in this video are available from Caddy Daddy below:

Motor and Cylinder Kit (5 Pieces) – https://bit.ly/6364motorcylinderkit
Pump Motor – https://bit.ly/6264pumpmotor
Cylinders (Pair) – https://bit.ly/6364cylinders
Hose Set (Pair) – https://bit.ly/6364hoseset
Header Kit (5 Pieces) – https://bit.ly/6164headerkit
Header Seal Weatherstrip Retainers (Pair) – https://bit.ly/6164headsealretainers
Roof Rail Rubber Weatherstrip Set (7 Pieces) – https://bit.ly/6164roofrailrubberset
Roof Rail Rubber Set Rear (Pair) – https://bit.ly/6164roofrailrubbersetREAR
Header Seal Weatherstrip – https://bit.ly/6164headersealweatherstrip
Vinyl Soft Boot – https://bit.ly/6164vinylsoftboot
Header Bow Guide Pin Sleeve Bushings (Pair) – https://bit.ly/6164guidepinbushings
Latch Assembly (Pair) – https://bit.ly/6164latchassembly
All Convertible Parts – https://bit.ly/convertibleparts

Visit the Boys & Girls Club of St. Helena and Calistoga website here – https://bgcshc.org
You can DONATE to the Boys & Girls Club of St. Helena and Calistoga here – http://bit.ly/bgcshcdonate